Ways to influence and extend the service life of CNC cutting machine

If a company buys any digital control product it wants to work longer, and the CNC cutting machine does the same. So how do you extend the service life of the CNC cutting machine? Here are some of the major reasons why the number of CNC cutting machines that can easily cause the life of a CNC cutting machine to slowly decrease:
A: There are many inhalable particles in the air. Most of the raw materials in many factories require powder processing. With the large air flow and dust in the outside, the local temperature in the CNC cutting machine is too high, causing hardware damage.
II: The internal temperature of the CNC cutting machine is too high. In environments where high temperature operation is required for a long time, the computer components are prone to aging and the frequency of hard disk failure is also higher than that of plasma cutting machines.
Third, the power supply voltage fluctuates greatly and is prone to blackouts. During mechanical manufacturing plant production, physical displacement actions such as dragging and vibration are performed.
Four: CNC plasma cutting machine IPC has a long working time. Due to the need for normal production, the industrial control systems of some factories need to work for a long time, which brings a huge test to the IPC operating system.
Of course, there are many reasons for the decrease in life span. For example, improper operator operation, non-sequential operation, and some bad operating habits will intangibly reduce the life span. Therefore, we should not neglect the small details.
Since we already know several major factors that affect the service life of CNC cutting machines, what are we doing to extend the service life of CNC cutting machines? The following is still a Wuhan resistance to give you a few ways to extend the service life of CNC cutting machine:
1. The application environment of CNC equipment is to improve the service life of CNC equipment. Common requests are to prevent the direct reflection of sunlight and other heat radiation, and to prevent places that are too moist, have too much dust, or have corrosive gases. The corrosive gas easily causes the electronic components to undergo corrosion and change, resulting in poor contact or short circuit between the components and affecting the normal operation of the device. Fine numerical control equipment should be kept away from large vibration equipment such as punch presses and forging equipment.
2. Power supply request In order to prevent the power supply from shaking large (greater than ±10%) and possible interference signals such as interference, CNC equipment usually uses dedicated power (such as from a low-voltage power distribution room for a separate use of CNC machine tools) or increase the voltage regulator Installation and so on, can reduce the impact of power quality and electrical interference.
3. Operational Procedures Operational procedures are one of the important measures to ensure the safe operation of CNC machine tools. Operators must operate according to operating procedures. In the event of a machine attack, the operator should pay attention to the preservation of the site and clarify the conditions before and after the failure to the maintenance personnel to facilitate the analysis and diagnosis of the cause of the problem and timely clean up.
In fact, CNC cutting machine as our production equipment, we should strengthen their love in daily life, to treat her like a family. Careful care can be used in exchange for longer use, in order to bring greater benefits to us.
Chinese cutting machine trading network, allowing you to buy the rest assured! A variety of CNC cutting machine and CNC cutting equipment, a variety of cutting machine models, let the optional! Official website: /

Pipeline and Flange Systems

Concrete pump pipeline systems

ST52 Pipe

Pipeline And Flange Systems,Pipeline Concrete Pumping,Concrete Pump Pipe,Concrete Pump Pipeline

HBYM GROUP Co,.LTD , https://www.hbympumpparts.com